geekhack Marketplace > RAMA WORKS
MACHINE INDUSTRIES CONFIGURATOR
RealLaugh:
Hey guys
I'm trying to make a simple CTRL + X macro for a cut command, but when I use the below combination the CTRL is getting stuck on. If I use the macro then when I go to use my keyboard it acts as if CTRL is still stuck down and I have to either switch layers or unplug the M10-a to stop it. Am I doing something wrong? Thanks!
Edit, I think I mixed up the way the arrows work thinking that down was up and up was down and so my macro was releasing the CTRL, pressing the key and then pressing the CTRL down instead of the other way around! Silly me...
Wren:
After installing the 0.2.0 configurator whenever I open the app it just hangs at the 'X 0' grid animation. Happens on both mac and windows. What am I doing wrong?
KingRama:
--- Quote from: Wren on Sat, 17 November 2018, 12:00:26 ---After installing the 0.2.0 configurator whenever I open the app it just hangs at the 'X 0' grid animation. Happens on both mac and windows. What am I doing wrong?
--- End quote ---
Hey mate! Which board are you trying to program? If it's the original M10-A use this configurator here: https://app.knops.io/ cheers :)
Wren:
--- Quote from: KingRama on Sun, 18 November 2018, 06:34:12 ---
--- Quote from: Wren on Sat, 17 November 2018, 12:00:26 ---After installing the 0.2.0 configurator whenever I open the app it just hangs at the 'X 0' grid animation. Happens on both mac and windows. What am I doing wrong?
--- End quote ---
Hey mate! Which board are you trying to program? If it's the original M10-A use this configurator here: https://app.knops.io/ cheers :)
--- End quote ---
Its the new M60A. You did a wonderful job on the hardware btw.
Wren:
I got it to work, the trick was turning off the mac's wireless keyboard. I think that was interfering with it. thanks!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version