geekhack Marketplace > Interest Checks
[IC] "Mix bag" plate GB
alixinhzai:
can u let me know ETA for this :D
The_Beast:
--- Quote from: TheProfosist on Tue, 30 October 2012, 01:30:33 ---
--- Quote from: The_Beast on Mon, 29 October 2012, 00:04:45 ---
--- Quote from: TheProfosist on Sun, 28 October 2012, 23:22:01 ---Im up for this as beast can get better pricing than i can dont really know what plates i want exactly yet all i know is i want stainless so i havnt filled out the form.
--- End quote ---
You can put other plate designs on the "others" section of the form
--- Quote from: TheProfosist on Sun, 28 October 2012, 23:39:05 ---16gauge stainless should work for costar thats what i got my phantom plates done in.
--- End quote ---
I found a caliper, the poker plate I had was between .059" and .061" depending on where I took the measurement.
--- End quote ---
thats aufully close and like i said worked on my phantoms
--- End quote ---
Yea +/- .005" costar will work, so a max of .065" and a min of .055" So having .059" to .061" are really nice considering
--- Quote from: alixinhzai on Tue, 30 October 2012, 01:40:54 ---can u let me know ETA for this :D
--- End quote ---
It will be after the poker plates and sometime during the GH60. If you REALLY need a plate PM me with the dwg and I'll run it. But just be aware that you're not going to get as good of a price since you'd only be ordering a few and not 95 of them (more = cheaper)
The_Beast:
I haven't contacted anyone else about anodizing, it's been such a busy week it's ridiculous. A couple test, a couple group meets and projects, volunteering today, teaching kids about physics tomorrow, research projects, the poker plate GB....
However my laser guy got back to me about thicker aluminum/stainless plates that I was planning on using for a case, The edge serration isn't the best but it is a laser and it's cutting to god damn light:
Navigation
[0] Message Index
[*] Previous page
Go to full version