ne update avail?
Sorry for the silence. Come summer break from university, I thought I would have more time though I've found a lot of things to do (outside) this summer and have been neglecting this project a bit especially after picking up the rendering gig I have for the keycaps people of this community. To be honest I've just been stuck on the PCB and need to reach out to some other people about putting this together. I'll admit, this isn't a fast IC, I'm not like some people of this community that can proposed and wiz to GB in 2 months.. whattya gonna do? ¯\_(ツ)_/¯
Here are a few things I've decided:
There will be indicator LED's which will be 3mm soldered-in diodes. There will be holes, I don't care much for the microdot aesthetic.
I am looking to add a rotary encoder knob to the upper right of the board (top of the 3-stack of keys)
I am pretty much set on this being a solder-board. Elitism aside, I just prefer it.
REALISTICALLY, this is going to have to be a limited buy (thinking 50) though I'm considering offloading the QC to a vendor to increase the number.
Knocking off some mounting points and might round up the corners by a few more millimeters.
Sorry I'm so slow everyone
appreciate all of the interest. I'll deliver. Just.. not right now.