OP, any update?
I am waiting until ghost juggernaut gets his and we will decide on what to do from there. Depending on quality, it could be possible to have them made on the U.S. If it is around the same price, I hope people don't mind waiting for them to be made in the U.S. I just want to see quality / how well packaged they are. And as far as cost go, I will invoice for case price + domestic shipping first, then once I get the bill for the international shipping I will calculate your percent, and once you pay the second invoice I will ship it out. If you end up not paying the 2nd one I will just refund.
sounds good with me, Im in no rush at all. Ive seen a lot of ICs go nowhere, so I was just wondering if you were still here basically
Yep! Just waiting to see quality/shipping quality. I would hate to order them and have half of them come broken or have them be cheap plastic
If your not too fussed its coming from me, they are good quality, the acrylic is around 7mm thick, the sides use a frosted acyclic while the base and lid use a clear acrylic the lid opens super smoothly without much problems, the only part required to build are the inserts inside the box which all just slot together I would advice using a little glue and you might need to heat them up as they come somewhat warped but fit very well overall the case is good, I suspect the one I ordered is only damaged due to the size but if possible I would recommend getting these cut in the US rather than ordering for overseas as you will get a lot with cracks just due to the cheaper acrylic used and its super hard to stop it cracking, just worried as if you plan to sell these you may end up with a lot coming back, I would recommend getting them made and using a thick acrylic like what Martinyeah used for his box, as that is almost impossible to break! also pictures!
Thats the damage that mine came with just as a fyi to you.
Showing how the keys stand up when the lid is on, I would recommend mounting this to a wall in a picture frame type move as it will look rather nice.
Just showing how they lean against the lid to stand
The lid
Has a little frosted bit glue to it to use as a handle.
Also the cracks are not all the way through just internal to the parts