Hello!
I been talking to the factory about what tolerances I have for these cases. The prototypes were very good, with some small flaws that would go unnoticed by most people, but I still want to make these better so that we get the highest possible quality out from the situation.
We had:
Some "stripes" on the side of the case, from the machining
Scratches on the brass weight(difficult to work with in this shape)
A few of the inner corners were not machined correctly.
We have been going through these small problems, and hopefully they have improved by our next prototype. The factory is very cooperative and they delivered an amazing products aside from these very small, almost unnoticeable flaws.
Shipping:
I am prepared to pay over 700$ in shipping to get these to me after I have placed the GB order, these are super heavy cases. From me, I will set up a solution with tracked shipping for everyone.
I am also figuring out some good options to include, and extras.
Thanks for reading, hopefully we will have some excellent prototypes so we can start this GB ASAP.