geekhack Community > geekhack Media

OTD 360c build log

<< < (4/4)


--- Quote from: Sup on Sun, 31 March 2024, 21:21:42 ---
--- Quote from: _rubik on Tue, 26 March 2024, 18:16:59 ---
--- Quote from: Sup on Sat, 23 March 2024, 15:45:27 ---Nice build, but those SMD could have been soldered way better. Try using tweezers makes it a breeze still takes good amount of time though.

--- End quote ---

For my edification, what do you mean by "using tweezers". I still do what OP did -- pull the legs through, bend them over so they don't fall over, flip the board, and tack them in place.

--- End quote ---

I am talking about the SMD diodes not the trough hole ones. Not everything is babied for you with old kits or niche kits  ;)

--- End quote ---

Oh right right, yes. Hot air flow station or bust. But then again, it's totally overkill for a single kit


[0] Message Index

[*] Previous page

Go to full version