/* INTRODUCTION:
 * -I've made ONLY the ISO 105 keymap
 * -For this ISO 105 you have to wire manually some key.
 * -hole for 6.25 spacebar stabilizer are in little wrong position (interax are more than 100 mm)
 * -right ALT is approx one millimeter in the wrong position, more on the 
 * left than normal and so it hurts a little bit the spacebar.
 * -I'm manually make the matrix because for the REV.2 there isn't it anywere...
 * 
 * REALIZATION:
 * In this way I made a standard ISO 105 with the GH80-3000 replica REV.2. If you make exactly
 * the same wiring you can use the JSON file I made and with that programming the layout you'll prefer on your keyboard.
 * -ISO enter: NO diode on D73 and wire it on D91 (IMG1)
 * -key on the left of ISO enter "]" (S51 on matrix): NO diode on D51 and wire it on D30.
 * -Number 3 of the keypad (S95 on matrix): NO diode on D95 and wire it on D117.
 * In this way I resolve the conflict I've found... It's the simple way I've found to resolve. I'm a Newby,
 * an industrial mechanic not an electronic expert so I don't know if it's the best way, but it finally works.
 * 
 *
 * NB: I've found a project error of position of the hole for the key on the right of the iso 6.25 spacebar. (position S104).
 * 
 * NB: I'm not the manifacturer, in the Future I'll hope to make a PURE ISO 105 that can work without wiring the 
 * conflict keys and solving the problem of position of the slots I found. Stay tuned. My website: www.vescovorestauri.it.
 *
 * Alessio Vescovo - Vescovo Restauri.
 *
 */