geekhack

geekhack Community => Keyboard Keycaps => Topic started by: capslockAndDropIt on Fri, 29 May 2020, 13:11:25

Title: Can anyone provide measurements of the RAMA Grid Keycaps?
Post by: capslockAndDropIt on Fri, 29 May 2020, 13:11:25

I'm working on a little project to refurbish an old espresso machine with new controls. I did my best to model the keycaps I'm planning to use but I don't have any real measurements. Wondering if someone could take some calipers to theirs and tell me how tall they are? I am trying to figure out the final positioning of my circuit board before I 3D print the housings.

[attachimg=1]

Title: Re: Can anyone provide measurements of the RAMA Grid Keycaps?
Post by: DALExSNAIL on Fri, 29 May 2020, 13:44:56

Quote from: capslockAndDropIt on Fri, 29 May 2020, 13:11:25

I'm working on a little project to refurbish an old espresso machine with new controls. I did my best to model the keycaps I'm planning to use but I don't have any real measurements. Wondering if someone could take some calipers to theirs and tell me how tall they are? I am trying to figure out the final positioning of my circuit board before I 3D print the housings.

(Attachment Link)

If you email him at his support email on the site, I think he'd be willing to provide this for you. Especially since it's for a personal project like this.

Title: Re: Can anyone provide measurements of the RAMA Grid Keycaps?
Post by: capslockAndDropIt on Fri, 29 May 2020, 14:02:09

I sent him a message on FB and got no response. I mean I can always wait until my keys arrive, but I was hoping to send out my PCB this week.

Title: Re: Can anyone provide measurements of the RAMA Grid Keycaps?
Post by: capslockAndDropIt on Sat, 30 May 2020, 20:11:20

I reached out to them via email and they hooked me. Props to RAMA!