geekhack
geekhack Community => Keyboards => Topic started by: vectorfrog on Thu, 11 August 2022, 11:36:09
-
I'm a newb. I've been following a youtube video on getting my Let's Split olkb set up using qmk toolbox. Everything looks good in qmk toolbox. When I hit reset, the signal is picked up, when I flash my hex file, I get a success message. But then, why I start typing on the keyboard, none of the keys work. I'm totally confused, and I don't know how to debug. Are the switches not properly contacting with the PCB? If so, how do I confirm that? Is there some special step I need to take because I'm on a Mac? I can't find a troubleshooting guide that addresses this stage of a successful flash, but the keystrokes not registering. Any tips or guides out there for this use case, or are there any services where I can pay someone to help me debug this?
Here's the tutorial that I'm following:
t=359s
-
Before flashing did the keys work? Most pcb's come pre flashed. Since all keys don't work it's probably the hex file.
Since you are this far into his tutorial I assume you have a working QMK environment. If your board is supported you should find the keyboard under the creators named folder and compile a default hex file and flash it from the command line. If that doesn't fix your issue then, your board could be faulty.
-
I've had it work right away then not work after unplug-plug and I've had some that needed an unplug-plug to work.