geekhack
geekhack Community => Keyboards => Topic started by: wabewawa on Mon, 10 October 2011, 07:23:13
-
Bringing this question to the most-viewed forum to see if I can get some more definitive info. It seems I'm not allowed to post internal links (?), as I tried to post a link to my original post from the Keyboard Key Caps sub-forum over at Ripster's forum, and that post apparently went into moderation oblivion, so I'll just repost the info here again. The original post and replies are, like I said, at the Keyboard Key Caps sub-forum (link up top on the front page of this forum), 4th down at this time.
Specs:
Beige Key Cap.
Heavy-duty beveled top design. For use with the above
keypad or pushbutton switches or any other keypads
or switches that use standard "Cherry Type"
3/4" sq. cruciform caps.
(http://www.smcelectronics.com/WNKC10.JPG)
Cap size: 0.715" sq. x 0.315".
Cruciform size: 0.160" x 0.150" deep.
About halfway down the page, just below the yellow (and double width farther down): http://www.smcelectronics.com/swkey.htm (http://www.smcelectronics.com/swkey.htm)
They would be for a Leopold in my case. I don't know what they mean by "standard." The stems seem a bit short to me. I wouldn't mind going lower profile if they'll work.
-
Looks like it
Sent from my Milestone using Tapatalk