geekhack

geekhack Community => Keyboard Keycaps => Topic started by: Preach on Sat, 12 January 2013, 00:49:17

Title: Having a bit of trouble putting the enter key back on QFR
Post by: Preach on Sat, 12 January 2013, 00:49:17

I decided to see how to take off the enter key in order to be ready for a set of keys that are coming in and now I can't seem to put it back on.

Any help would be greatly appreciated.

Title: Re: Having a bit of trouble putting the enter key back on QFR
Post by: rowdy on Sat, 12 January 2013, 01:10:08

This is for Filco, but both use the same stabilisers:

Title: Re: Having a bit of trouble putting the enter key back on QFR
Post by: Preach on Sat, 12 January 2013, 01:14:15

Quote from: rowdy on Sat, 12 January 2013, 01:10:08

This is for Filco, but both use the same stabilisers:

thank you. been searching for a while with no results.

Title: Re: Having a bit of trouble putting the enter key back on QFR
Post by: hoggy on Sat, 12 January 2013, 01:15:54

Beaten to it.  Nevermind.

Title: Re: Having a bit of trouble putting the enter key back on QFR
Post by: Preach on Sat, 12 January 2013, 01:21:58

i got the key on but now it doesnt push back up unless i pull a little bit.

Title: Re: Having a bit of trouble putting the enter key back on QFR
Post by: hoggy on Sat, 12 January 2013, 01:26:56

Take it off and try again - should clear it. 

Title: Re: Having a bit of trouble putting the enter key back on QFR
Post by: Preach on Sat, 12 January 2013, 01:31:42

found the error. i had put a white piece in backwards.

thank you everyone for helping

Title: Re: Having a bit of trouble putting the enter key back on QFR
Post by: rowdy on Sat, 12 January 2013, 05:44:02

No worries :)

Once you have done a couple of these, it becomes second nature.

Title: Re: Having a bit of trouble putting the enter key back on QFR
Post by: cobraj on Sat, 12 January 2013, 15:56:38

Quote from: rowdy on Sat, 12 January 2013, 05:44:02

Once you have done a couple of these, it becomes second nature.

Indeed it does.
However after only using Filco's, I managed to pull out the stabilisers of my KBT Race as it feels a lot less solid than a Filco :(