geekhack
geekhack Community => Keyboard Keycaps => Topic started by: Wopian on Mon, 04 February 2013, 09:47:31
-
Filco Majestouch 2 uses Itallic Futura and 9 font size correct?
-
It's definitely Futura... no idea on size
-
Yes, both the font and the size.
I used WASDKeyboards to "convert" a French AZERTY board to QWERTY. In natural light, you can see that the laser engraving is slightly brighter then the stock Filco one. Under a strong light, you can see that the plastic is quite different too, but I don't notice under normal use.
In the photo, QWEAZ\ are from WASD, the other letters are from the stock Filco.
-
Do you happen to know the font size of enter character (Wingding 3 I assume) on the full uk majestouch 2?
Cheers
-
Yes, both the font and the size.
I used WASDKeyboards to "convert" a French AZERTY board to QWERTY. In natural light, you can see that the laser engraving is slightly brighter then the stock Filco one. Under a strong light, you can see that the plastic is quite different too, but I don't notice under normal use.
In the photo, QWEAZ\ are from WASD, the other letters are from the stock Filco.
Can you confirm that the profile on the WASD keys is a little bit higher than that of the same Filco key?
I have an unused set of Filco ABS keycaps that I may put on another board with a WASD 37 keyset. I was wondering about the consistency of the keys and whether the height would be different.
-
Yes, both the font and the size.
I used WASDKeyboards to "convert" a French AZERTY board to QWERTY. In natural light, you can see that the laser engraving is slightly brighter then the stock Filco one. Under a strong light, you can see that the plastic is quite different too, but I don't notice under normal use.
Can you confirm that the profile on the WASD keys is a little bit higher than that of the same Filco key?
No, the plasticprofile is the same far as I can tell.
After a bit of use, it looks like the Filco keys got more wear and tear.
-
Yes, both the font and the size.
I used WASDKeyboards to "convert" a French AZERTY board to QWERTY. In natural light, you can see that the laser engraving is slightly brighter then the stock Filco one. Under a strong light, you can see that the plastic is quite different too, but I don't notice under normal use.
Can you confirm that the profile on the WASD keys is a little bit higher than that of the same Filco key?
No, the plastic is the same far as I can tell.
After a bit of use, it looks like the Filco keys got more wear and tear.
Wow, you've been gone a while! A reply after 2y 9m 3d :D
-
Yes, both the font and the size.
I used WASDKeyboards to "convert" a French AZERTY board to QWERTY. In natural light, you can see that the laser engraving is slightly brighter then the stock Filco one. Under a strong light, you can see that the plastic is quite different too, but I don't notice under normal use.
Can you confirm that the profile on the WASD keys is a little bit higher than that of the same Filco key?
No, the plastic is the same far as I can tell.
After a bit of use, it looks like the Filco keys got more wear and tear.
Wow, you've been gone a while! A reply after 2y 9m 3d :D
+ 4 hours 8 minutes 12 seconds :p