geekhack
geekhack Marketplace => Vendor Forums => Signature Plastics / PimpMyKeyboard => Topic started by: dante on Fri, 10 October 2014, 14:01:10
-
You already stock POM sets from Cherry (http://keyshop.pimpmykeyboard.com/products/specialty-custom-keys/cherry-g81-3000-keycaps-original-laser-etched-keys). I'm curious if you could produce some keycap sets with this POM/Delrin plastic - even if they were only blank (I'm not sure if doubleshot POM is even possible)? DCS would be fine - but SA would also be outstanding. :eek:
-
in for blank black dsa
-
bump
-
bump
Their silence is deafening...maybe they are too busy counting the dollars from the latest GB, lol.
(http://i.giphy.com/6corUUdXB4WkM.gif)
:p
-
bump
-
bump
Have you tried emailing them?
-
No response!
-
Keep in mind, Melissa, their main contact with the outside world, just had a baby a couple weeks ago.
-
No response!
Be patient, Melissa is out on extended leave. Bob is slowly handling the emails.
-
Bob is doing a fine job, in my limited experience.
-
Bob is doing a fine job, in my limited experience.
I am not picking on him...it just seems to be slower in getting responses now that Melissa is away
-
Sorry for the delay! Unfortunately POM (Acetal) has too much shrink to run in our ABS tooling - the result would be unacceptable cosmetic parts - sorry!
-
Sorry for the delay! Unfortunately POM (Acetal) has too much shrink to run in our ABS tooling - the result would be unacceptable cosmetic parts - sorry!
No problem. Thanks for the reply!