geekhack
geekhack Community => Keyboards => Topic started by: ezrahilyer on Thu, 06 November 2014, 16:55:14
-
You know you have gone too far when you get into trouble for running barrel plates and cases through the dishwasher.....
Yep.
-
Last time I ran a barrel frame through the dishwasher, everyone was okay with it. It allowed us to run a 1/2 load and get the DW ready for a full fill after dinner.
-
How many did you wash?
-
How many did you wash?
usually it's one at a time since I haven't ended up with bulk model Ms.
-
How many did you wash?
usually it's one at a time since I haven't ended up with bulk model Ms.
Sorry, actually the question was aimed at OP :)
I was wondering how many were being washed at the same time. One or two would be ok, but I could understand the elevated level of concern if five or more keyboards were involved!
-
How many did you wash?
that load was 4 barrel plates, and 3 top plates and 3 bottom plates (labels removed)
so yeah it did take up pretty much the whole bottom of the dishwasher.
I have been only doing one at a time, but I got several in at once, so I wanted to get ahead of the curve! :-)
-
you know you've gone too far when you suck **** for keycaps
-
How many did you wash?
that load was 4 barrel plates, and 3 top plates and 3 bottom plates (labels removed)
so yeah it did take up pretty much the whole bottom of the dishwasher.
I have been only doing one at a time, but I got several in at once, so I wanted to get ahead of the curve! :-)
I think that explains it :p
-
you know you've gone too far when you suck **** for keycaps
Bros4Brojobs
-
you know you've gone too far when you suck **** for keycaps
sorry to hear. hope you got some nice caps out of it though.
-
you know you've gone too far when you suck **** for keycaps
Bros4Brojobs
There's going to have to be a support group in off-topic