geekhack
geekhack Projects => Making Stuff Together! => Topic started by: dothm on Fri, 01 May 2015, 01:58:18
-
Hello Geekhack coming from New Zealand
I need someone to check the measurements of my 60% case i made (in sketchup cause i'm a noob) to see if everything is laid out correctly. I used a poker plate drawing from swill's plate building tool to get the standoffs in the correct position (6 mm deep) and I guesstimated where the micro usb slot goes. Once this case is finished i'm planning on making this case open source.
P.S I'm not a hobbit
[attach=1]