I can help you with that Lunaris. I think you should recognize my name from r/mk. Shoot me a pm here or there, doesn't matter.Done. Appreciate it!Show Image(http://i.imgur.com/SqxfwcT.jpg)
I'd love to help but you picked a bad time. :( Saving my cash for Purple Gaterons and Rainbow POMs ...
Hello ika - I *might* be interested. The only sticking point is that I'm still undecided exactly what to get. I'm thinking of getting a b.face x2 pcb with soldered controller, diodes, LEDs and resistors. Do you happen to know the accepted way to choose resistor values?
Btw, I'm going to solder on the newly available purple switches. Other than that, I'm not sure where I'll be going with it.
If you can get someone else to jump on this while I decide, go for it. I may still wait for the JD45 board and do that instead anyway.
Good luck....
You choose resistor values in the comments section when checking out
On his 60% he recommends 820 for all colors, I would assume bpad is the sameHello ika - I *might* be interested. The only sticking point is that I'm still undecided exactly what to get. I'm thinking of getting a b.face x2 pcb with soldered controller, diodes, LEDs and resistors. Do you happen to know the accepted way to choose resistor values?
Btw, I'm going to solder on the newly available purple switches. Other than that, I'm not sure where I'll be going with it.
If you can get someone else to jump on this while I decide, go for it. I may still wait for the JD45 board and do that instead anyway.
Good luck....You choose resistor values in the comments section when checking out
Actually there's a dropdown selection for resistor values when choosing options for the PCB. Hojin uses 820, 910, and 1300ohm resistors. Higher resistor values are ideal for orange, red, and yellow LEDs, and white/blue LEDs would be dimmer. The inverse is true with lower value resistors - "normal" for white/blue LEDs, but maybe too bright for red/orange/yellow. Other than that, I don't have any experience with his LEDs. I was planning on using 1300 ohm to be able to use socketed LEDs and since I usually put my LEDs on the dimmest setting anyway.
Not sure if you've already done this/when you want to do it, but I'll be on board in like two weeks maybe, need to recover from the Zealios order financially.
I'm getting payed sometime in the next week, so I should be ready to make the purchase then if I have the money left over after various GBs I want to enter. I'll make a new thread as well if you want when that time comes around.Not sure if you've already done this/when you want to do it, but I'll be on board in like two weeks maybe, need to recover from the Zealios order financially.
I'm still looking for someone! I'm putting Zealios on mine too so I don't think waiting will be a big deal. I feel like I should start a new thread, since I know OP already completed his buy and not everyone reads threads through.