geekhack
geekhack Community => Keyboards => Topic started by: asgeirtj on Sun, 11 October 2015, 11:59:12
-
So when getting new switches it is one thing to test them individually or in a switch tester, and another thing to test them in a whole board.
I realized this when I thought that 65g clears were good in the switch tester, bet when on a whole board I realized they are way too heavy for me.
The difference is that your fingers will be at a different angle with a whole board and you will be using all your fingers. Maybe it's possible to take this into account when using a switch tester to some extent? I'm not sure.
So there comes the question, how do you test your switches for real life situations? Do you simply solder a whole board? I'm thinking that maybe soldering the home row + enter would be enough, or is it not?
-
If I was going to make a commitment to solder my own board, I would try the switches out on several different boards that have them installed until I find out EXACTLY what I like, even if it doesn't exist. Soldering takes time and effort (even more for me since I suck at it), so I wouldn't want to re-do it ever.
-
get a board where you can swap switch tops, you can try out your preferences without having to solder and desolder.
-
If I were going to test all the different switches, I would probably go to a GH meetup, or I would get one board with switches that I wasn't familiar with, try them out, and if I didn't like them, I would trade it on for another board with different switches until I found the ones I like the most. At that point, I would sell the board, and use that for the switches I wanted (That or just desolder the board, and use those switches.)
-
get a board where you can swap switch tops, you can try out your preferences without having to solder and desolder.
Or this... I forgot that was a thing... lol
-
Can't you just mount all the switches onto the plate without soldering them onto the PCB? I know the feel wouldn't be 100% the same, but if the plate is sturdy it should be pretty close.
-
Can't you just mount all the switches onto the plate without soldering them onto the PCB? I know the feel wouldn't be 100% the same, but if the plate is sturdy it should be pretty close.
Depending on the plate and its tolerances, MX switches can wobble a lot without a PCB to help hold it all together.