geekhack
geekhack Community => Keyboards => Topic started by: ZippY_S on Sun, 15 May 2016, 09:05:55
-
Good afternoon, I had a problem with the keyboard Ducky Shine 3, I examine her, took the body, disabled PCB of the controller, cleaned the keyboard and plugged back in, but it has ceased to work, the keyboard is the power, but it is not lit and is not determined by the PC. I live in Russia, I bought it on this site: http: //****en.pro/, it ended guarantee and so I decided to disassemble and clean it. What do i do? = ((
-
Check the wires where the cable connects to the PCB - they are thin and not made to move, so break easily.
What did you use to clean it?
-
Check the wires where the cable connects to the PCB - they are thin and not made to move, so break easily.
What did you use to clean it?
compressed air
-
Do you already tried to disassemble the board and check everything: connectors, pcbs, ribbon cables, etc?
Is it possible that a controller can be damaged by static electricity while being disassembled?
-
Have you tried resetting the board? How down both Win keys for at least 3 seconds (while it is plugged in). The LEDs should flash a couple of times while it is resetting.
Or you could try updating the firmware.
-
Have you tried resetting the board? How down both Win keys for at least 3 seconds (while it is plugged in). The LEDs should flash a couple of times while it is resetting.
Or you could try updating the firmware.
Yes i tried ,my pc dont see keyboard (sorry for my english)
-
What was wrong with the Shine 3 before you took it apart? When you put it back together did you make sure the black wires were on the top position and the red wire on the bottom? If the connector was connected the wrong way then the board might be fried since a lot of people have fried the Shine 3 by connecting it the wrong way when putting it back together.
-
Have you tried resetting the board? How down both Win keys for at least 3 seconds (while it is plugged in). The LEDs should flash a couple of times while it is resetting.
Or you could try updating the firmware.
Yes i tried ,my pc dont see keyboard (sorry for my english)
Your English is fine - 100% better than my Russian!
Can you try the keyboard on a different computer?
Can you try a different USB cable?
Even a different USB port on your computer?
-
Have you tried resetting the board? How down both Win keys for at least 3 seconds (while it is plugged in). The LEDs should flash a couple of times while it is resetting.
Or you could try updating the firmware.
Yes i tried ,my pc dont see keyboard (sorry for my english)
Your English is fine - 100% better than my Russian!
Can you try the keyboard on a different computer?
Can you try a different USB cable?
Even a different USB port on your computer?
Can you try the keyboard on a different computer?-
Can you try a different USB cable? +
Even a different USB port on your computer? +
Bios dont see
-
I have run out of ideas.
Perhaps the controller on the PCB has been zapped :(