geekhack

geekhack Community => Keyboards => Topic started by: mniels on Thu, 06 April 2017, 11:15:45

Title: issue resetting Pok3r
Post by: mniels on Thu, 06 April 2017, 11:15:45

Not sure if anyone else has seen this, but the red LED on the spacebar is lit and I am unable to change layers or reset back to default (by holding Fn+R.)

At this point the board is not functioning at all.  It is acting as if in the middle of programming even though it is not.

Anyone have a fix for this?

Title: Re: issue resetting Pok3r
Post by: SpAmRaY on Thu, 06 April 2017, 11:48:43

I assume you've tried the obvious unplug and plug it back it etc.


https://geekhack.org/index.php?topic=76242.0

Maybe this thread might have some helpful info?

Title: Re: issue resetting Pok3r
Post by: mniels on Thu, 06 April 2017, 11:53:35

Turned out it was the fourth dipswitch, back up and running now.