geekhack
geekhack Community => Keyboards => Topic started by: Sgt_4Leaf on Wed, 11 July 2018, 16:57:00
-
Hello Ya'll,
I need to open up my Cooler Master CM storm QuickFire Pro (what a short catchy name, huh).
Where can I find reliable data of how to do that properly?
Also, would anyone happen to know if it is normal to be required to type a verification code and the same stupid "A Popular serial bus for keyboard connectivity" question prior to each and every post and reply?
Thanks in advance,
-
I've not disassembled a coolermaster in a few years but if there are any bottom screws remove them, probably one under the sticker.
Then use a spudger or some thin plastic pry tool and carefully separate the top and bottom half, there are probably plastic clips to release.
And the verification goes away after 10 posts I think.
I didn't search but there could be a thread on this buried in the deep.
Sent from my SM-G930V using Tapatalk
-
I've not disassembled a coolermaster in a few years but if there are any bottom screws remove them, probably one under the sticker.
Then use a spudger or some thin plastic pry tool and carefully separate the top and bottom half, there are probably plastic clips to release.
And the verification goes away after 10 posts I think.
I didn't search but there could be a thread on this buried in the deep.
Sent from my SM-G930V using Tapatalk
Thanks..
-
there was like a whole forum dedicated to modding qfrs lol
but yes it's 1 under the sticker and then pop the clips with a credit card