geekhack
geekhack Community => Off Topic => Topic started by: tp4tissue on Wed, 05 December 2018, 14:36:47
-
Just tested it out on new dws779 miter..
[attachimg=1]
Pros:
Smooth cutting..
Flawless finish, even with high cut speed.
Virtually no blowout bottom or back
Definitely no sanding required..
Cons:
Makes an extreme shrieking noise.. (Not sure if my blade is broken)
Extremely Thin plate.. ?!?!?
The vibration dampener must be a gimmick, cuz WTH, it's so high pitched..
Cost twice as much as other brands..
-
That's nice and all but do you still have your fingers?
-
I haven’t tried that exact blade but am surprised that it is so noisy. As a general rule, the smaller gullets from the greater number of teeth usually make the blade quieter. A miter saw’s blade will seem noisier than the same blade in a tablesaw. The blade noise is dampened by most of it being contained in the tablesaw’s body.
-
I haven’t tried that exact blade but am surprised that it is so noisy. As a general rule, the smaller gullets from the greater number of teeth usually make the blade quieter. A miter saw’s blade will seem noisier than the same blade in a tablesaw. The blade noise is dampened by most of it being contained in the tablesaw’s body.
Yea I called up the Diabro peeps, they said something may be wrong with the blade..
I tried several blades, hitachi , cheap overpeak, dewalt vanilla, none make this shrieking sound..
The noise isn't during the cut, only when free spinning..
-
Wish I could use a saw without being squeamish
-
Zomg.. Did y'all know , can cut newspaper bundles on miter saw ?
Wow.. so easy..