geekhack
geekhack Community => Keyboard Keycaps => Topic started by: WheresTheSNES on Thu, 10 January 2019, 11:32:43
-
Is it safe to put GMK keycaps on Cherry MX Clear switches without stretching the keycaps?
I know they fit tighter, but do they damage caps similar to old box switches?
I have a Vortex Core w/ Clears I was planning to kit out with a Space Cadet set.
Thanks
-
Is it safe to put GMK keycaps on Cherry MX Clear switches without stretching the keycaps?
I know they fit tighter, but do they damage caps similar to old box switches?
I have a Vortex Core w/ Clears I was planning to kit out with a Space Cadet set.
Thanks
seemed fine on all the boards i've done it on
-
Great. Hopefully you're right, because I did it anyway! Cherry profile isn't great on a 40% with no incline, but, whatever.
-
I do not hear too many horror stories with Clears... box switches are a different story
-
I do not hear too many horror stories with Clears... box switches are a different story
DSA with clears i know has some problems, but my GMK soware set is fine and it's been on clears for a year
-
I think the issue with clears is not destroying the cap but the cap destroying the snug switch.
On my clear board trying to take off one of those NPKC caps tore the capslock switch out of its housing. Made sure to use spudgers while removing from then on, but now I just don't swap caps on it.
-
Yup, you'll be fine :thumb:
Most of my boards have MX Clears and GMK caps with zero issues.
-
No problems for sure!
GMK caps made with the same tooling as the old OG Cherry keycaps, they sholud be fine. No problems with my MX Clears and old OG Cherry doubleshots on my G80-9009. No signs of damage on the stems either. They're 23 years old now.
-
I do not hear too many horror stories with Clears... box switches are a different story
DSA with clears i know has some problems, but my GMK soware set is fine and it's been on clears for a year
DSA have been specifically designed to be super tight on clears (as per client requests).
-
Only thing to watch out for is pulling caps. Sometimes you’ll pull the top of the switch off with the cap on clears. It’s fine if you have a plate with switch opening cutouts or a hotswap board. If not, you may have to desolder to get it back together