Filco Keycap Font & Size?

[Wopian]

Filco Majestouch 2 uses Itallic Futura and 9 font size correct?

[remmeh]

It's definitely Futura... no idea on size

[dezs]

Yes, both the font and the size.

I used WASDKeyboards to "convert" a French AZERTY board to QWERTY. In natural light, you can see that the laser engraving is slightly brighter then the stock Filco one. Under a strong light, you can see that the plastic is quite different too, but I don't notice under normal use.

In the photo, QWEAZ\ are from WASD, the other letters are from the stock Filco.

[SavageCore]

Do you happen to know the font size of enter character (Wingding 3 I assume) on the full uk majestouch 2?

Cheers

[Grim Fandango]

Yes, both the font and the size.

I used WASDKeyboards to "convert" a French AZERTY board to QWERTY. In natural light, you can see that the laser engraving is slightly brighter then the stock Filco one. Under a strong light, you can see that the plastic is quite different too, but I don't notice under normal use.

In the photo, QWEAZ\ are from WASD, the other letters are from the stock Filco.

Can you confirm that the profile on the WASD keys is a little bit higher than that of the same Filco key?

I have an unused set of Filco ABS keycaps that I may put on another board with a WASD 37 keyset. I was wondering about the consistency of the keys and whether the height would be different. 

[dezs]

Yes, both the font and the size.

I used WASDKeyboards to "convert" a French AZERTY board to QWERTY. In natural light, you can see that the laser engraving is slightly brighter then the stock Filco one. Under a strong light, you can see that the plastic is quite different too, but I don't notice under normal use.

Can you confirm that the profile on the WASD keys is a little bit higher than that of the same Filco key?

No, the plasticprofile is the same far as I can tell.
After a bit of use, it looks like the Filco keys got more wear and tear.

[jdcarpe]

Yes, both the font and the size.

I used WASDKeyboards to "convert" a French AZERTY board to QWERTY. In natural light, you can see that the laser engraving is slightly brighter then the stock Filco one. Under a strong light, you can see that the plastic is quite different too, but I don't notice under normal use.

Can you confirm that the profile on the WASD keys is a little bit higher than that of the same Filco key?

No, the plastic is the same far as I can tell.
After a bit of use, it looks like the Filco keys got more wear and tear.

Wow, you've been gone a while! A reply after 2y 9m 3d

[rowdy]

Yes, both the font and the size.

I used WASDKeyboards to "convert" a French AZERTY board to QWERTY. In natural light, you can see that the laser engraving is slightly brighter then the stock Filco one. Under a strong light, you can see that the plastic is quite different too, but I don't notice under normal use.

Can you confirm that the profile on the WASD keys is a little bit higher than that of the same Filco key?

No, the plastic is the same far as I can tell.
After a bit of use, it looks like the Filco keys got more wear and tear.

Wow, you've been gone a while! A reply after 2y 9m 3d

+ 4 hours 8 minutes 12 seconds