« previous next »
Pages:  [1]     Go Down

Author Topic: All parts ready  (Read 4134 times)

0 Members and 1 Guest are viewing this topic.

Offline DanielOh

  • Thread Starter
  • Posts: 58
  • Location: Houston, TX
All parts ready
« on: Mon, 15 April 2019, 15:50:50 »
Finally, I've collected all the parts for my new Planck!
I guess I can finish this project on the coming weekend!

P.S I'm going to hand wired it. And I'm worried..
« Last Edit: Mon, 15 April 2019, 15:52:59 by DanielOh »
Logged

Offline HPE1000

  • Keycap Paparazzo
  • Posts: 2943
  • Location: Carolina Beach, NC
Re: All parts ready
« Reply #1 on: Mon, 15 April 2019, 16:46:28 »
Are you going to use the hot swap sockets just so you don't have to solder the cream legs and make them never able to be used with a hot swap board?
Logged

Offline DanielOh

  • Thread Starter
  • Posts: 58
  • Location: Houston, TX
Re: All parts ready
« Reply #2 on: Mon, 15 April 2019, 19:48:44 »
Yes. Cream switches are much expensive compare to hotswap.
« Last Edit: Mon, 15 April 2019, 19:50:35 by DanielOh »
Logged

Offline DanielOh

  • Thread Starter
  • Posts: 58
  • Location: Houston, TX
Re: All parts ready
« Reply #3 on: Tue, 16 April 2019, 19:07:00 »
So tired..
Logged

Offline HPE1000

  • Keycap Paparazzo
  • Posts: 2943
  • Location: Carolina Beach, NC
Re: All parts ready
« Reply #4 on: Tue, 16 April 2019, 21:11:02 »
Nice! That's really well done.  :thumb:
Logged

Offline DanielOh

  • Thread Starter
  • Posts: 58
  • Location: Houston, TX
Re: All parts ready
« Reply #5 on: Tue, 16 April 2019, 21:37:01 »
And this is final keyboard!
Logged

Offline Coreda

  • Posts: 780
Re: All parts ready
« Reply #6 on: Tue, 16 April 2019, 21:46:37 »
Build looks super clean to my untrained eye. Nice effect with the almost pixel-looking gradation of the key cap selection.
Logged
Pages:  [1]     Go Up
« previous next »