Wow, that's a good PCB, DOX!
I especially like the profusion of mounting holes. We sholud have no trouble with flex.
Are they one-sided PCB's with a lot of jumpers, or does the red denote traces on the second layer?
Thanks, these are 2 sided. The red traces are on the top layer of the PCB.
Nice one, Dox! My eyes started to follow the traces - it wasn't long before I got lost.
Thanks, it's quite hard to follow from the picture, especially with the ground planes.
Can u buy me a PCB set please I can't wait for a final kit!
FYI, the prototype PCBs cost me ~300$ for 2 sets. Prices will be much lower with bigger quantity but I ordered the minimum qty just to test everything.
that's awesome, DOX!
Thanks! Your firmware highly facilitate the tracing. I don't know if I have followed your intended matrix as I went for the simplest way to trace it with the assigned pins. There will probably be some remapping needed in the firmware. No big deal.
Will the PCBs be available a la carte?
Yes, when everything will be ready and tested!
Nom, I'm with dirge on this! Can I buy a PCB?
I don't think a lot of people would want to pay 150$ for a set of PCB that are not even tested yet.
I should receive them next monday. Can't wait!