« previous next »
Pages:  [1]     Go Down

Author Topic: Alpaca V2 has inconsistent stem hole size?  (Read 1028 times)

0 Members and 1 Guest are viewing this topic.

Offline jooobe

  • Thread Starter
  • Posts: 219
  • Location: USA
Alpaca V2 has inconsistent stem hole size?
« on: Wed, 09 June 2021, 08:20:28 »
I'm wondering if anyone has run into this, I'm stem swapping to UHMWPE stems. The same stem can fit into one bottom housing but somehow not some other ones. If I look closely some stem hole has thicker walls than other ones
Logged

Offline Leopard223

  • Posts: 228
Re: Alpaca V2 has inconsistent stem hole size?
« Reply #1 on: Sat, 12 June 2021, 10:53:36 »
I can see that happening, tolerance is probably meant for the Alpaca stem.
Just like when making Holy Bobas, some switches will have the stem stuck due to different sizes.
Logged

Offline _PixelNinja

  • Posts: 473
  • C=Q/V=ε(A/t)
Re: Alpaca V2 has inconsistent stem hole size?
« Reply #2 on: Sat, 12 June 2021, 11:24:57 »
Quote from: jooobe on Wed, 09 June 2021, 08:20:28
I'm wondering if anyone has run into this, I'm stem swapping to UHMWPE stems. The same stem can fit into one bottom housing but somehow not some other ones. If I look closely some stem hole has thicker walls than other ones

The culprit is more likely the UHMWPE stems than the Alpacas. UHMPE stems are notorious for having noticeable variance from one unit to another.
Logged
Pages:  [1]     Go Up
« previous next »