Does anyone use these with my firmware? I need to know if the new version works.
I'm using it... was actually browsing this (and it's thread) looking for some answers. It seems to be working well in general, but I'm unable to use alt codes in macros or access the config menu with it. I assume the former is due to the lack of a numlock key on my main board (TKL).
I tried using \NUMLK, at the beginning and end of the macro but it errors during compile saying unrecognized escape sequence.
Setting a config menu key outputs nothing. Im guessing due to the fact that it's not a full keyboard? I wasnt sure if config would work utilizing number and enter keys on my main board or if they had to be on the AVR board. I was looking to enable "unlink num lock" and "virtual num pad" this way to allow for alt codes, but I could be going about this incorrectly.