Everything laid out before soldering
Parts:
- RS68 kit from
怡科外设- Lipless Clear acrylic case w/ silver plate and silver feet
- Gateron Clear (linear) sring
- 90g spring on Spacebar
- Lubed w/ 1:1 mixture of silicone grease + Victorinox oil
- Clear stabilizers w/ 1.2mm foam tape and silicone grease
- Clear white 2*3*4mm LEDs
-
keyboard layoutthe switches were lubed 2 months ago... procrastination's a *****. finally decided to get this started and done with
Saw these clear stabilizers on taobao and decided to test it out. as expected they are quite rattly, I've shared this video before but
here you go again
I used a piece of 1.2mm-thick foam tape underneath the stabilizers and lubed with thick silicone grease. It reduces the rattle significantly and keep the stabilizers in place.
The LED on the top-right switch refused to light up, not sure if the missing resistor on R131 position caused this.
I soldered a resistor on R131 and fly-wire to the next LED pads then the LED lit up with half the brightness.