Author Topic: IBM Model F space bar difficulty trying to put it back  (Read 2643 times)

0 Members and 1 Guest are viewing this topic.

Offline supermario802.1

  • Thread Starter
  • Posts: 36
    • tinkerBOY
IBM Model F space bar difficulty trying to put it back
« on: Sat, 25 August 2018, 11:13:31 »
I was in a hurry to clean my IBM Model F keyboard and removed all keys including the space bar which I had a bit difficulty in removing it. I suspect I should not have done it but I did it anyway. So is there a way to put it back without disassembling the whole keyboard?

Offline fohat.digs

  • * Elevated Elder
  • Posts: 6556
  • Location: 35°55'N, 83°53'W
  • weird funny old guy
Re: IBM Model F space bar difficulty trying to put it back
« Reply #1 on: Sat, 25 August 2018, 11:54:08 »
Not if it is one of the small ones, an XT or an AT.

There is a long "under-carriage" assembly that goes into the plate like the barrels and installs from below. I use a weighted thread to hold the pieces in place while I press them together.
“So, instead, all too many people try an untenable middle way -- sanctifying Trump and anyone in his inner circle while trying to maintain standards on everyone else. It simply can't work. When your leaders are hateful and nihilistic then your movement becomes hateful and nihilistic. ”
~ David French

Offline supermario802.1

  • Thread Starter
  • Posts: 36
    • tinkerBOY
Re: IBM Model F space bar difficulty trying to put it back
« Reply #2 on: Sat, 25 August 2018, 16:39:07 »
Not if it is one of the small ones, an XT or an AT.

There is a long "under-carriage" assembly that goes into the plate like the barrels and installs from below. I use a weighted thread to hold the pieces in place while I press them together.

Ok thanks! I guess I'll have to open it up.


Offline ThoughtArtist

  • Posts: 310
  • Location: A climate-controlled testing facility
Re: IBM Model F space bar difficulty trying to put it back
« Reply #4 on: Sat, 01 September 2018, 00:27:49 »
The spacebar from hell