Author Topic: IBM Model F space bar difficulty trying to put it back  (Read 2588 times)

0 Members and 1 Guest are viewing this topic.

Offline supermario802.1

  • Thread Starter
  • Posts: 36
    • tinkerBOY
IBM Model F space bar difficulty trying to put it back
« on: Sat, 25 August 2018, 11:13:31 »
I was in a hurry to clean my IBM Model F keyboard and removed all keys including the space bar which I had a bit difficulty in removing it. I suspect I should not have done it but I did it anyway. So is there a way to put it back without disassembling the whole keyboard?

Offline fohat.digs

  • * Elevated Elder
  • Posts: 6543
  • Location: 35°55'N, 83°53'W
  • weird funny old guy
Re: IBM Model F space bar difficulty trying to put it back
« Reply #1 on: Sat, 25 August 2018, 11:54:08 »
Not if it is one of the small ones, an XT or an AT.

There is a long "under-carriage" assembly that goes into the plate like the barrels and installs from below. I use a weighted thread to hold the pieces in place while I press them together.
As George Orwell put it:
Journalism is printing what someone else does not want printed; everything else is public relations.

Offline supermario802.1

  • Thread Starter
  • Posts: 36
    • tinkerBOY
Re: IBM Model F space bar difficulty trying to put it back
« Reply #2 on: Sat, 25 August 2018, 16:39:07 »
Not if it is one of the small ones, an XT or an AT.

There is a long "under-carriage" assembly that goes into the plate like the barrels and installs from below. I use a weighted thread to hold the pieces in place while I press them together.

Ok thanks! I guess I'll have to open it up.


Offline ThoughtArtist

  • Posts: 310
  • Location: A climate-controlled testing facility
Re: IBM Model F space bar difficulty trying to put it back
« Reply #4 on: Sat, 01 September 2018, 00:27:49 »
The spacebar from hell