« previous next »
Pages:  [1]     Go Down

Author Topic: HELP. on Vortexgear Core firmware update  (Read 1060 times)

0 Members and 1 Guest are viewing this topic.

Offline basix

  • Thread Starter
  • Posts: 7
HELP. on Vortexgear Core firmware update
« on: Sat, 01 June 2019, 12:05:45 »
Yesterday I received the Core 40% and all worked fine until I ran a firmware update V1.04.06. It was then I lost the ability to enter programming mode using the Fn + R_Ctr keys.

I can still enter different layers using the Fn key but I cannot enter programming mode, nor does the R_Spacebar LED blue light go on.
Logged
Pages:  [1]     Go Up
« previous next »