« previous next »
Pages:  [1]     Go Down

Author Topic: Ergodox case with tenting  (Read 2068 times)

0 Members and 1 Guest are viewing this topic.

Offline Linuus

  • Thread Starter
  • Posts: 2
Ergodox case with tenting
« on: Sun, 20 October 2019, 08:49:12 »
I built an Ergodox about 5 years ago with parts from Falbatech mainly. I have a PVC case from Falbatech which works fine but it’s not as nice and polished as something like the Ergodox EZ of course :) Also, it doesn’t have any tenting.

Are there any nice cases that I can buy today with tenting? The only I’ve found are also from Falbatech: https://falba.tech/product/ergodox-standard-pvc-case-ver3/

https://falba.tech/product/ergodox-standard-bamboo-wood-case-with-oil-finish/

Has anyone tried them? Are they good?
« Last Edit: Sun, 20 October 2019, 09:27:38 by Linuus »
Logged

Offline ddot

  • Master of Suspense
  • Posts: 166
  • Location: Canada
Re: Ergodox case with tenting
« Reply #1 on: Tue, 22 October 2019, 13:07:23 »
The old Massdrop Ergodox cases were held together with M3 screws.  You could just get M3 extenders and raise one side.  Not sure how your Falbatech case is built though.

https://geekhack.org/index.php?topic=50020.msg1086814#msg1086814
https://www.ebay.ca/itm/Brass-M2-M3-Hex-Column-Standoff-Support-Spacer-Screw-Nut-PCB-Board-25-50-100pcs/302755099164
Logged

Offline Findecanor

  • Posts: 5081
  • Location: Koriko
Re: Ergodox case with tenting
« Reply #2 on: Tue, 22 October 2019, 13:32:36 »
I have found these to 3D print, but I don't know if they will fit Falbatech's case specifically:
https://www.thingiverse.com/thing:787658
https://www.thingiverse.com/thing:1433117

I have also seen people's home-made wedges made of foam or wood.
Logged
🍉
Pages:  [1]     Go Up
« previous next »