« previous next »
Pages:  [1]     Go Down

Author Topic: How to fix stabilizers without desoldering?  (Read 5804 times)

0 Members and 1 Guest are viewing this topic.

Offline snarfarlarkus

  • Thread Starter
  • Posts: 185
How to fix stabilizers without desoldering?
« on: Tue, 10 December 2019, 15:59:14 »
My stabilizer wires have disconnected from the plastic stems and I do not know how to reconnect them without having to desolder the whole board? This picture kind of shows whats happening: https://imgur.com/a/xQ3B4DY

As you can see the left stab cannot go as low as the right stab. If I have to I will desolder and resolder the whole board but I just want some insight on how to fix this without? Thanks!
Logged

Offline wholypantalones

  • Posts: 878
  • Location: The Mitten
  • text and icon mods plz.
Re: How to fix stabilizers without desoldering?
« Reply #1 on: Tue, 10 December 2019, 17:05:40 »
I'm guessing the bar came unclipped on the high side and is sitting under the slider. Take a pair of tweezers and slide the bar out as far as it goes and seat it back in the slider hole and clip the bar back into the base with the tweezers.
Logged

Offline snarfarlarkus

  • Thread Starter
  • Posts: 185
Re: How to fix stabilizers without desoldering?
« Reply #2 on: Tue, 10 December 2019, 23:30:57 »
Is there any video on how to do this? Just tried for a solid 15 minutes to no avail
Logged
Pages:  [1]     Go Up
« previous next »