Honestly, been a while and I just wanted to check back in for anyone unfortunate enough to be in my situation. I fixed it, with a lot of hopes a prayers. The ubreakifix took the board for a week, said they couldn’t fix it, and gave it back. I ended up using what suicidal_orange said and used magnetic wire to directly connect the switch to the pin on the chip, seeing as how I couldn’t find any other solder points. It was ugly, and I did it by using kapton tape on the other legs. I put it there using tweezers, and pretinned the iron and the wire. I ended up pretty much not using any more solder because the joint was so small and hard to get at. I taped down the rest of the excess wire using the nonconducting kapton tape and I think it should be fine. The picture of the 2 tapes side by side is the one that I just finished, and the excessive tape is the permanent version. I just wanted to thank orange for his help, couldn’t have done it without you bro.