Made some fine tuning yesterday and added the holes so I can countersunk the hex screws.
Also made a better radii in the corners (that was changed), for the Phantom plate it's no problem, but the filco plate it was a squeese. And that is due to the edges not beeing chamfered.
The Phantomplate had a whole 1.5mm in the corners. The filco plate only got 0.25mm... all due to the edges being 90°, but it would fit. Barely.
I made the radius smaller so we get more room. But then the screws will be exposed, but I had it like that in the "pre teensy fix" design, so no problem really.
So now the filco will drop in a bit easier. (the holes only guides the screw, no thread on these holes)
Other than that, I need to get my teacher to look at it. And we'll see how realistic my design is. I have some places that I think I need to change.
The cable channel is one of them. The chamfered edges probably needs to go(A). Will also fix the radius(B), so I don't need to use a 2mm bit.
Try and spot another potential problem, saw it now as I'm writing this