Yes, PCB is based off the poker PCB and case. However, when komar originally did the PCB's, he used standoff positions from the plastic case, which I found to be slightly off and does not perfectly line up with the PCB. Their plastic mold to make cases are off. This is where the discrepancy is. I took all my measurements using the PCB instead of the case, which should be more accurate for locations. Final GH60 PCB should have correct locations when we're done working this out, same with Poker PCB.
To do so, the usb connector should be changed to ones as I linked above.
If you use SMD fixing type, the four smd lead will not allow you to have the same connector position as PokerX's.
(The USB connector should come out a little to be in the same position as PokerX's)
When 38GT PCBs were made in OTD, they measured the original housing too. This caused some problem...
I'd like you not to make the same mistake.
To be honest, I don't think this is developers' fault(OTD, GH...).
Rather, that is the fault of PokerX's developers.
The position of USB is not exactly middle of the two switches(ESC and 1).... very strange. No reason can be found to do so...
Not only the USB connector, the DIP switch is not posed in the middle of the two switches.
I don't think they had any "WORKMANSHIP of Perfection".
If I had designed PokerX, I would never have left them such a way.... awkward...
Then... is it OK that I believe what you told(you will fix the positions), and design a new housing for PokerX(in fact for GH60)?