« previous next »
Pages:  [1]     Go Down

Author Topic: Is it possible to put on a plate after you solder the mx-switches to the PCB?  (Read 2393 times)

0 Members and 1 Guest are viewing this topic.

Offline LaugeGregers

  • Thread Starter
  • Posts: 9
  • Location: Denmark
Is it possible to put on a plate after you solder the mx-switches to the PCB?
« on: Wed, 29 January 2014, 01:17:22 »
I am building an ErgoDox, and today I get the last part, so I can begin to build it. But I don't have a plate, as I am waiting for my friend finish his 3D printer, so he can print me a case.
I wondered if I could build the keyboard, solder the switches in place, and then just put the plate on later. Or do I have to put on the plate, and then solder the switches in?
Logged

Offline bueller

  • MX baller
  • * Esteemed Elder
  • Posts: 3769
  • Location: Perth, Australia
  • Church of the Ergo Clear
Re: Is it possible to put on a plate after you solder the mx-switches to the PCB?
« Reply #1 on: Wed, 29 January 2014, 01:18:47 »
Quote from: LaugeGregers on Wed, 29 January 2014, 01:17:22
I am building an ErgoDox, and today I get the last part, so I can begin to build it. But I don't have a plate, as I am waiting for my friend finish his 3D printer, so he can print me a case.
I wondered if I could build the keyboard, solder the switches in place, and then just put the plate on later. Or do I have to put on the plate, and then solder the switches in?

Nope, not possible unfortunately.
Logged
Quote from: HoffmanMyster on Tue, 20 January 2015, 19:52:41
It's a good width!  If it's half-width it's too narrow, and full-width is too wide. 

[WTT] bueller's trade thread - CLACKS WANTED
Pages:  [1]     Go Up
« previous next »