« previous next »
Pages:  [1]     Go Down

Author Topic: Getting into a CM Switch tester  (Read 1260 times)

0 Members and 1 Guest are viewing this topic.

Offline skiwithpete

  • Thread Starter
  • Posts: 29
Getting into a CM Switch tester
« on: Sun, 11 January 2015, 20:24:36 »
Hey guys,

I got a CM Switch Tester and I want to make it into a custom 6 switch keyboard (my first DIY).

But I can't seem to get into the case...

Anyone have a strategy they can share?

I just can't figure out which side the lip is on or how to release it.

Logged
Co-Founder of 1upkeyboards.com

QFR Brown + PokerII Clear

Offline skiwithpete

  • Thread Starter
  • Posts: 29
Re: Getting into a CM Switch tester
« Reply #1 on: Sun, 11 January 2015, 21:17:49 »
I figured it out.  You gotta aim for the 1/4 way-in marks on the front and back panels.  Trying to do it in the middle just won't yield any results.

Logged
Co-Founder of 1upkeyboards.com

QFR Brown + PokerII Clear

Offline SpAmRaY

  • NOT a Moderator
  • * Certified Spammer
  • Posts: 14667
  • Location: ¯\(°_o)/¯
  • because reasons.......
Re: Getting into a CM Switch tester
« Reply #2 on: Sun, 11 January 2015, 21:32:08 »
There are at least two threads on here where people put a teensy in these, they might be helpful to you.

I'd link you but I'm on my phone.
Logged

Offline Grendel

  • Posts: 462
  • Location: OR, USA
    • Firmware for Costar Replacement Controllers
Re: Getting into a CM Switch tester
« Reply #3 on: Sun, 11 January 2015, 21:48:51 »
Logged
Currently using: RK-9000WH/GR, CMS QFXT w/ Ghost Squid
- I'm game !
Pages:  [1]     Go Up
« previous next »