Author Topic: SP DCS ISO kit profiles  (Read 2349 times)

0 Members and 1 Guest are viewing this topic.

Offline synerr

  • Thread Starter
  • Posts: 95
  • Location: London
SP DCS ISO kit profiles
« on: Fri, 23 January 2015, 15:22:46 »
The ISO kit at has only 2 keys besides the left shift and Enter, the |\ and ~#.    That would leave the 2@, '" and 3# keys untouched from the US Ansi layout.

What sense does that make, if any at all?

Which layout would make the most of that configuration?  US International?  It's OK but not fond of the dead keys.

Press any key to continue, any other key to quit.

Offline Findecanor

  • Posts: 4301
  • Location: Stockholm, Sweden
  • Dans öl tarvö... "Pöngö"
Re: SP DCS ISO kit profiles
« Reply #1 on: Fri, 23 January 2015, 15:39:53 »
You're right. It is neither. It happens to be the convention for group buys to let the ISO kit contain only those kits though ... Probably to keep the cost down.

Offline LechnerDE

  • * Esteemed Elder
  • Posts: 2631
  • Location: Germany
Re: SP DCS ISO kit profiles
« Reply #2 on: Tue, 27 January 2015, 01:18:01 »
The reason is that there are just too many ISO variants. It wouldn't make sense to cover all the needed keys.

The ISO kit is just meant to fill the gap, so you could use an ANSI set on your ISO board at all.