« previous next »
Pages:  [1]     Go Down

Author Topic: Stabilizer hole orientation on a plate?  (Read 2707 times)

0 Members and 1 Guest are viewing this topic.

Offline 27

  • Thread Starter
  • Posts: 752
  • Location: Ottawa, Ontario, Canadeh
  • The Maple Man
Stabilizer hole orientation on a plate?
« on: Wed, 13 April 2016, 19:53:33 »
I've been working on modifying the TGR-Jane files that yuksti provided, and I'm pretty unsure about the stabilizer cutout orientation.  I'll be using the GON NerD TKL PCB, so A.87 compatible.

Plate


What the plate should support


If anyone could give me some pointers or in the right direction of some good resources that would be awesome!

Basically, does the wire side, or the other side of the stabilizer get the indent in the hole?
« Last Edit: Wed, 13 April 2016, 20:04:02 by 27 »
Logged
IG: https://www.instagram.com/27mechs/                                        Website: http://www.mech27.com/

Offline Photekq

  • wheat flour zone
  • Posts: 4794
  • Location: North Wales, UK
  • sorry if i was ever an ******* to you
Re: Stabilizer hole orientation on a plate?
« Reply #1 on: Wed, 13 April 2016, 19:54:36 »
Depends entirely on the PCB being used.
Logged
https://kbdarchive.org/
github
discord: hi mum#5710

Offline 27

  • Thread Starter
  • Posts: 752
  • Location: Ottawa, Ontario, Canadeh
  • The Maple Man
Re: Stabilizer hole orientation on a plate?
« Reply #2 on: Wed, 13 April 2016, 19:55:53 »
Quote from: Photekq on Wed, 13 April 2016, 19:54:36
Depends entirely on the PCB being used.

Whoops, Gon's NerD TKL, so A.87 compatible.
Logged
IG: https://www.instagram.com/27mechs/                                        Website: http://www.mech27.com/

Offline kiwi99

  • that's a gnarly dookie
  • Posts: 748
  • Location: Vancouver, BC
  • authentic church of halverson member
Re: Stabilizer hole orientation on a plate?
« Reply #3 on: Wed, 13 April 2016, 20:08:28 »
That plate looks like it supports everything you specified there, you can double check
you can always overlay this pcb files you can get on gons site http://www.gonskeyboardworks.com/manuals/131-nerd-pcbs.html
to see if it makes sense.

Red holes are PCB mount stab holes, make sure they line up with the where the plate has the slightly bigger cutouts.

edit: attached .dxf you need if you're lazy ;)
Logged
Pages:  [1]     Go Up
« previous next »