I'm having problems programming my PCB. I get the "Connected" pop-up in the JigOn software but it registers no keypresses there. It works fine in Windows.
I'm not able to update or reset the firmware either, so I guess it's not actually connected. I've tried four different USB ports (half of them directly on the motherboard) and three different USB cables. No luck.
Any suggestions?
Couple of things to check:
Is your OS set to English US?
Is it the only keyboard that's plugged in?
Is your phone plugged in?
If you download a fresh copy of the JigOn software, launch it and hit connect does it download the keymap or does everything stay gray?
If you connect and then switch to notepad and start typing what output do you get?
My OS is set to English US, yes.
It's the only board that's plugged in, my phone is not plugged in.
The JigOn software looks like this after connecting:
https://i.imgur.com/zFZdSYo.pngTyping in Notepad gives me this output:
"åd+c¨åd+d¨åd+e¨åd+c¨åd+d¨åd+e¨åd+f¨åd+h¨åd+g
So I guess that might be causing the issue. Not sure why it's showing up like that when my keyboard and OS is set to en-US.
EDIT: I just realized that I still had the Danish keyboard layout added in the language menu, apparently it wasn't enough to just switch to the en-US layout, I had to remove the Danish layout. Now it works!