Here is HakFoo's case side view:
And Pacifist's:
Now, HakFoo was able to it fit two layers on top and two below PCB, and Pacifist only one on top and two below. The difference arises due to thickness of the actual acrylic in the two cases.
Alright, so I think one of the middle layers with the USB cutout should work fine for everybody. Now, I was seeing if this would work and it should, however the inner wall between screw hole and PCB cutout will be almost negligible, and as stated earlier, this should be a non-issue because of pressure from above and below layers. But shipping will be and they might break easily. So what I propose of everyone is okay with this is that I have the correct size cutout for the PCB but near the holes, I will have tabs so they are as thick as earlier and you can file those 2-3mm tabs down. I will also suggest everyone take two of these layers.
Now for the colors:
- Most people had clear matte or black matte except jdcarpe, Pacifist, metalliqaz.
- jdcarpe, you had orange layer just below the top, would you be fine in using all clear matte? I can get you two layers in the amended design and one in the older design (To replace bottom orange). Or do you want to go with the orange? Please PM me.
- Pacifist, I don't see you using the pink layer! I think if we get you the clear matte layer to go below the top, then you can sandwich your pink layer there.
- metalliqaz, one of your cases was white, so how do you want to proceed?