Here are some pictures of the case and an assembly guide
Everything included for the case. Most of it you will not use.
Step 1: Assemble the three middle layers and insert the brass standoffs so they are in the middle.
Step 2: Put on the plate and screw in the short flat-head bolts. DO NOT TIGHTEN THESE
(No picture)
Step 3: Put on the back cover. Screw in the bottom two short flat-head bolts. Make sure these are tight.
Step 4: Assemble the feet. I found 5 layers has the best angle for me. Use the longer flat-head bolts. Make sure these are tight.
Done!
Alternate method
Instead of using the acrylic feet, you can use rubber thingies.
Pic of it assembled
Also, I am packing up all the orders today and should have everything shipped out today or tomorrow.