I'm not understanding why you need those long drill holes for the mount screws. This is a new, from scratch board. You can put the standoffs anywhere you want.
True. Does allow for some error, but not much
Anyway, I was just copying what others have done and figure there's a reason for it. I noticed they seem to be on my Pure pcb. Didn't seem to hurt, so I've just kept them.
I was actually going to try and drill them out myself, but there are also some places where solder pads are completely missing, as well as a trace. And this is on the SMD diode pad and switch pin hole.
It's like that on all three boards, so something got screwed up somewhere.
That's disappointing. This is what I got back with my little testers.
The slot and the hole came out ok. Also the 3 overlapping drills on the USB. Measurements with the caliper show it as pretty much bang on.
I wish the board edges were cut clean though, instead of those annoying little partially broken tabs.