« previous next »
Pages:  [1]     Go Down

Author Topic: issue resetting Pok3r  (Read 1217 times)

0 Members and 1 Guest are viewing this topic.

Offline mniels

  • Thread Starter
  • Posts: 164
issue resetting Pok3r
« on: Thu, 06 April 2017, 11:15:45 »
Not sure if anyone else has seen this, but the red LED on the spacebar is lit and I am unable to change layers or reset back to default (by holding Fn+R.)

At this point the board is not functioning at all.  It is acting as if in the middle of programming even though it is not.

Anyone have a fix for this?
« Last Edit: Thu, 06 April 2017, 11:22:11 by mniels »
Logged

Offline SpAmRaY

  • NOT a Moderator
  • * Certified Spammer
  • Posts: 14667
  • Location: ¯\(°_o)/¯
  • because reasons.......
Re: issue resetting Pok3r
« Reply #1 on: Thu, 06 April 2017, 11:48:43 »
I assume you've tried the obvious unplug and plug it back it etc.


https://geekhack.org/index.php?topic=76242.0

Maybe this thread might have some helpful info?
Logged

Offline mniels

  • Thread Starter
  • Posts: 164
Re: issue resetting Pok3r
« Reply #2 on: Thu, 06 April 2017, 11:53:35 »
Turned out it was the fourth dipswitch, back up and running now.
Logged
Pages:  [1]     Go Up
« previous next »