« previous next »
Pages:  [1]     Go Down

Author Topic: Solder pads seem to be gone, best fix?  (Read 953 times)

0 Members and 1 Guest are viewing this topic.

Offline Bulliba

  • Thread Starter
  • Posts: 11
Solder pads seem to be gone, best fix?
« on: Thu, 13 August 2020, 10:17:38 »
I noticed the \| switch isnt working so I took the board apart and desoldered the switch, looks like this underneath. What would be the best fix? I can't activate the key using tweezers either. I've briefly read about bridging but I'm not sure what I would bridge it to in that case.
Logged

Offline suicidal_orange

  • * Global Moderator
  • Posts: 4771
  • Location: England
Re: Solder pads seem to be gone, best fix?
« Reply #1 on: Thu, 13 August 2020, 10:40:00 »
The bottom pad goes to the top of the diode labeled D11, the diodes connect across the rows so I guess the top pad would connect to the top pin of the A switch.  Short the top pin of A to the diode for /| to check before soldering :)
Logged
120/100g linear Zealio R1  
GMK Hyperfuse
'Split everything' perfection   		MX Clear
SA Hack'd by Geeks     
EasyAVR mod

Offline Bulliba

  • Thread Starter
  • Posts: 11
Re: Solder pads seem to be gone, best fix?
« Reply #2 on: Thu, 13 August 2020, 10:55:55 »
Thank you!  :D
Logged
Pages:  [1]     Go Up
« previous next »