Bleeeeh. Took the time tonight to put my Orion v2's Alps PCB/plate into the Mira again just for fun, along with a few cap changes too. It took foreeever to change out all the sets and switch between boards.
I've figured out that the set I idealized for it, the IBM Multistation hi pros, isn't as good of a fit for the Mira as I had thought. They're uncomfortable to type on, probably because of a combination of the angle on the Mira and the depth of the scooping with these caps. To put it in perspective, the normal scoops are as deep as the C.Itoh caps' homing key scoops.
Here's a few potatoes of all the past night's mucking about:
The Canon caps are -not- the same profile, but they fit well enough. If I felt that they fit the Mira better, I might've done something to blend them in with the Multistation caps.
The last two are brother sets.
Ultimately, I think I'm gonna go back to the ICL One Per Desk caps on the Mira.