Comparison of P-Touch labeled cap with doubleshot cap:
This photo compares a doubleshot cap from SP with a P-Touch label on a relegendable cap. The label was made with a P-Touch PT-18R with a TZe135, 1/2-inch white-on-clear tape.
Better view of the SA-R3 relegendable labeled cap:
I trimmed the label on the sides but kept the full 1/2-inch height. The bottom part of the cap is just a tiny fraction smaller than the label.
Different angle of the SA-R3 relegendable cap:
You can see where the label overlaps the top ridge of the cap.
Side profile comparison of the relegendable:
It's not a great photo, but the caps look and feel the same.
Different label placement:
Since the SA-R3 relegendable caps are not deep dish, I labeled the front of one of the blank deep dish caps, to use as a homing key. This was before I realized the NDG-SA-R3 base kit came with deep dish F and J caps. This is using the same helvetica-a-like typeface, with the large font size.
Different angle of label placement:
For this label, I trimmed all 4 sides of the label, around the letter. I placed it close to the top edge of the cap to make it more visible. Most other labeled blank caps have the label mounted low, closer to the bottom edge. In the past, I have put P-Touch labels on the top surface of keys, and they hold up well over time, and can be removed cleanly.