Installed some backlighting last night and what I think will be the final keyset that will sit on this board maybe add some artisans. The 7u stab wire is a bit sticky.. it makes the spacebar get stuck down a bit sometimes.. hard to change that now but I might desolder the space bar switch and fiddle with the stab a bit.
My bad, I should've said something. Sometimes stabs (this goes for all of them, not just Chinese ones) can get stuck by not being bent at exactly 90 degree angles. When this happens, the ends of the stab wires will press against the sides of the stabilizer housings, creating friction which causes the perceived stickiness. Lube can alleviate the issue, but the best way to resolve it is to use pliers or such and adjust the angles slightly until the spacebar is smooth. I've only had this happen to me once but I should've made a disclaimer - that's on me.
Remaining r2 shipments are being prepped right this moment stateside while I'm fulfilling TriC orders (a separate buy that also encountered severe delays) - should be done with the latter in a few hours. I've got the missing plates (or rather, plates that I thought were missing) sorted out.