« previous next »
Pages:  [1]     Go Down

Author Topic: [help] AMJ pad led not working  (Read 1888 times)

0 Members and 1 Guest are viewing this topic.

Offline Munnybear

  • Thread Starter
  • Posts: 12
[help] AMJ pad led not working
« on: Fri, 07 October 2016, 14:43:35 »
Hi,

I have an AMJ number pad that works fine with no led. However, when I tried to add LED to the num lock it wouldn't light up. I only want to tell if the num lock is on. Much appreciated for any helps!

Munny
« Last Edit: Fri, 07 October 2016, 21:59:50 by Munnybear »
Logged

Offline Munnybear

  • Thread Starter
  • Posts: 12
Re: [help] AMJ pad led not working
« Reply #1 on: Sat, 08 October 2016, 08:05:37 »
I am thinking if this has anything to do with the firmware as I did flush it with my custom configs and I did not write anything for lighting...
Logged

Offline suicidal_orange

  • * Global Moderator
  • Posts: 4771
  • Location: England
Re: [help] AMJ pad led not working
« Reply #2 on: Sat, 08 October 2016, 08:37:11 »
Sounds likely, that or the LED is in backwards?
Logged
120/100g linear Zealio R1  
GMK Hyperfuse
'Split everything' perfection   		MX Clear
SA Hack'd by Geeks     
EasyAVR mod

Offline Munnybear

  • Thread Starter
  • Posts: 12
Re: [help] AMJ pad led not working
« Reply #3 on: Sat, 08 October 2016, 09:32:20 »
Quote from: suicidal_orange on Sat, 08 October 2016, 08:37:11
Sounds likely, that or the LED is in backwards?

Pretty sure it was... long end through the square hole... right?
Logged

Offline Data

  • Posts: 2608
  • Location: Orlando, FL
Re: [help] AMJ pad led not working
« Reply #4 on: Sat, 08 October 2016, 14:26:31 »
Quote from: Munnybear on Sat, 08 October 2016, 09:32:20
Quote from: suicidal_orange on Sat, 08 October 2016, 08:37:11
Sounds likely, that or the LED is in backwards?

Pretty sure it was... long end through the square hole... right?
That's the standard polarity.

Did you test the LED before you installed it?  Did you also install a resistor?
Logged
Pages:  [1]     Go Up
« previous next »